SG Connect - Installer test
Purpose
To make a quick check that all luminaires in a group are well-commissioned and work as expected. A simple switch on/off or dimming command can be given to the group to verify that commissioning was done as desired.
How to
Tap the three dots and choose “Enable Test Mode”. Now the whole group of lights or individual luminaires can be switched on and off with the app.
With the red bar the dim level of the luminaires in the group can be controlled. Verify that all luminaires respond properly! In test mode the response of the luminaires is not immediate and might need a few seconds.
After testing leave the test environment by going back one screen (arrow in upper left corner).
Step-by-step guide
Remarks
Dim levels of the luminaires using the test mode are influenced by the configured field task levels of the devices. A field task level of 100% is recommended.
Identifying groups and single device by blinking
Purpose
You can easily identify a group or single light with the command “Turn on identifying by blinking”.
How to - identify on group level
Press the three dots to the right of the group name.
Select “Identifying by blinking” from the list.
The luminaires in the Group start to blink. The blinking will stop automatically after a while.
Step by step - identify on group level
How to - identify on device level
Open the group.
Press the three dots to the right of the device name.
Select “Identifying by blinking” from the list.
The light starts to blink. The blinking will stop automatically after a while.
Step by step - identify on device level
